Replacing Internal Modules - NEC DX2000 User Manual

Chapter 5 Replacing Modules
1.

Replacing Internal Modules

This section describes the instructions and precautions for replacing the modules installed in this server.
1.1
Safety Precautions
Be sure to observe the following precautions for replacing modules properly and safely.
Important
 We recommend that Maintenance service company who is approved by
NEC should replace the modules.
 Use only the modules specified by NEC. You will be charged to repair
damages, malfunctions, and failures caused by the use of any devices or
cables not specified for use with this server even within the warranty
period.
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety precautions in Precautions for Use.
● Do not disassemble, repair, or modify the server.
● Do not remove the lithium battery, NiMH battery, or Li-ion battery.
Disconnect the power plug when installing and removing devices.
●
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use.
Do not drop
●
Do not leave the server being pulled out.
●
● Make sure to complete installation.
Do not install with the cover removed.
●
Do not get your fingers caught.
●
● High temperature
Electrical shock
●
Scalable Modular Server DX2000 User's Guide
WARNING
CAUTION
1. Replacing Internal Modules
85