Setting Required For Using Serial Over Lan (Sol) - NEC DX2000 User Manual

Chatpter 3 Setup
4.4

Setting Required for Using Serial over LAN (SOL)

SOL is the feature that enables management terminals to access to this server via an IP network.
Besides operating this server using RemoteKVM in section 4.3, you can use SOL to display and operate the
POST screen and the BIOS SETUP Utility screen.
To enable this feature, specify the settings below.
Operation on the management terminal
Start the terminal emulator and specify the communication condition in IPMI command as follows:
#ipmitool -I lanplus -H [IP address] -U [BMC-user]
-P [password] sol activate
IP-address: BMC IP address of target
BMC-user: Administrator
Password: Administrator
Operation on the management terminal
SOL is enabled by default setting. You cannot change setting.
Scalable Modular Server DX2000 User's Guide
4. Connection to BMC
71