Writing Error Log Data To The Cf Card - Brother RH-9820 Service Manual

3. READING/WRITING DATA

3-8. Writing error log data to the CF card

0729B
3-9. Updating the main control program
0725B
3-10. Updating the panel control program
0726B
25
1. Select W6 in data read/write mode.
2. Press the ENTER key.
The error log in the sewing machine will be written to the CF card.
The memory switch settings will also be written at this time.
However, the file destination will be different from the one mentioned in "3-7."
above.
Once writing is complete, the buzzer will sound.
3. Press the TEST key.
Data read/write mode will end.
1. Select R5 in data read/write mode.
2. Press the ENTER key.
A confirmation message will be displayed.
3. Press the ENTER key. (If you press the RESET key, the operation will be
canceled.)
Firmware updating will start. (It should take about one minute.)
Once writing is complete, an "UPDATED SUCCESSFULLY" message and the
power off symbol will be displayed.
4. Push the POWER switch to the OFF side to turn off the power, and then turn the
power back on again.
1. Select R7 in data read/write mode.
2. Press the ENTER key.
A confirmation message will be displayed.
3. Press the ENTER key. (If you press the RESET key, the operation will be
canceled.)
Firmware updating will start. (It should take about three minutes.)
Once writing is complete, a "COMPLETED" message and the power off symbol
will be displayed.
4. Push the POWER switch to the OFF side to turn off the power, and then turn the
power back on again.
RH-9820