Brother RH-9820 Service Manual page 112

6. ASSEMBLY
G
H
Assemble while referring to the finished assembly diagram shown below.
I
<For -02 specifications only>
Install to the feed base (a) as shown in the illustration below.
J
<For -02 specifications only>
Install so that the centers of the pin holes (e)
and (f) are at the distance shown in the
illustration.
(When at maximum retraction)
103
(Right side )
(Left side )
Set the clamp lever shaft (10) so that the amount
of protrusion at the end is as shown in the
illustration, then assemble crank lever B (13) so
that there is no clearance between it and the inside
of the clamp lever shaft (10), and then tighten the
socket bolt (14).
(The left side is the same.)
K
<For -01 and -02 specifications only>
Install at the distance shown in the illustration.
(When at maximum retraction)
1001B
RH-9820
(Right side )
(Viewed from underside)
0998B
0999B
1000B
1002B