Brother RH-9820 Service Manual page 84

6. ASSEMBLY
A
Tie one end of the wick (1) once, and then push that end into the hole (a) in the support shaft base (43).
* Push in so that the knot does not protrude from the hole (a).
B
1) Tie one end of the wick (8) once, and then push that end into the hole (b) in the LS holder base (34).
* Push in so that the knot does not protrude from the hole (b).
2) Tie the other end of the wick (8) to one end of the wick (9), and then wind them around the LS holder
base (34) as shown in the illustration.
* Tie the wicks twice to form the knot.
* Wind so that the knot is directly below the hole (c) and so that it does not protrude to the outside.
* Wind the wick (8) and the wick (9) so that they are positioned as shown in the illustration.
(Viewed from the left)
75
(Viewed from the front) (Viewed from the right)
RH-9820
(Viewed from the front)
1184B
1185B