Brother RH-9820 Service Manual page 18

2. FUNCTION SETTINGS
Panel operation settings
Setting
No.
range
Disabling program mode
OFF
350
ON
Disabling cycle program mode
351 OFF
ON
Disabling changing of production counter
352 OFF
ON
Disabling changing of sewing speed
353 OFF
ON
Disabling changing of program number
OFF
354
ON
Disabling changing to cutting before sewing
OFF
355
ON
Disabling changing to cutting after sewing
OFF
356
ON
User program settings
Setting
No.
range
Maximum sewing speed (rpm)
450
1000 - 2500
Maximum number of cycle programs
451
0 - 9
Production counter when using cycle programs
452 OFF
ON
Maximum cutting space (mm)
453
0.5 - 0.8
Maximum straight bartack length (mm)
454
6 - 9
Additional zigzag width when no cutting is set (mm)
455
0 - 1.0
9
Normal
Switching to program mode is disabled.
Shortcut keys are also disabled.
Normal
Switching to cycle program mode is disabled.
Normal
Changing the production counter is disabled.
Normal
Changing the sewing speed (parameter No. 01) is disabled.
Normal
Changing the program number is disabled.
* However, the steps in cycle programs can be changed.
Normal
Changing to cutting before sewing is disabled.
* If cutting before sewing is the current setting before this is changed, the setting will
change automatically to no cutting.
Normal
Changing to cutting after sewing is disabled.
* If cutting after sewing is the current setting before this is changed, the setting will
change automatically to no cutting.
A limit to the maximum sewing speed can be set.
Setting can be carried out in units of 100 rpm.
The number of effective cycle programs can be set.
* If cycle programs are never used, it can be useful to set this to 0.
The counter is updated each time a buttonhole is sewn.
The counter is updated each time a single cycle is completed.
This sets the maximum value for the cutting space.
* If setting this to 0.8 mm, adjust so that the needle plate and the throat plate do not
interfere with each other. (Refer to "7-20. Adjusting the positions of the work clamp
plates".)
This sets the maximum straight bartack length.
* If setting this to 9 mm, adjust so that the needle plate and the throat plate do not
interfere with each other. (Refer to "7-20. Adjusting the positions of the work clamp
plates".)
When sewing using no cutting, the value set here is added automatically to the zigzag
width.
Setting can be carried out in units of 0.1 mm.
Setting items
Setting items
RH-9820
Default
value
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Default
value
2500
9
OFF
0.5
6
0