Brother RH-9820 Service Manual page 85

C
Hook the longer end of twist spring R (19) onto
spreader R (13), and pass the shorter end through
the hole in the LS holder base (34) as shown in the
illustration.
E
Hook the thread take-up spring (53) onto the hook
(d) of the L thread take-up spring support (54) as
shown in the illustration.
D
1) Push the felt (23) into the hole in the looper link
(25).
2) Tie the wick (24) around the looper link (25) as
shown in the illustration.
* Make a double knot in the wick (24), and
then cut off the excess length so that the
ends are 2 - 3 mm in length.
1094B
F
1) Hook the wick onto the hook (e) of the L thread
take-up spring support (56) as shown in the
illustration.
2) Raise the end of the hook (e) of the L thread
take-up spring support (56) so that it touches the
support shaft base (43), and then tighten the
screw with washer (57) at that position.
* This will prevent the wick from pulling away.
1096B
RH-9820
6. ASSEMBLY
1095B
1097B
76