Brother RH-9820 Service Manual page 146

6. ASSEMBLY
C
Cord holder (20) installation
Narrow
side
D
Tapping in the oil pot window
E
Inserting the wicks
137
1) Install the cord holder (20) so that the side with
Wide
side
2) Secure the oil tube (7) behind the cord presser
1) Insert the oil tube (6) and the oil tube (b)
2) Check that the wick (c) is attached to the base
1) Insert the four wicks (d) into the arm relay hole
2) Push in the felt (31).
RH-9820
the wider hook is on the right as shown in the
illustration, and then while gently pushing it in
the direction of the arrow, tighten the two
screws (21) to secure it in place.
(20) and the stop switch cord (a) with the cord
presser (22).
coming from the oil plate assembly (26) into the
oil tank.
of the oil tank, and then tap in the oil gauge
window (30).
(e).
* Insert the four wicks (d) securely into the
holes as far as they will go.
* A list of the four wicks (d) is as follows.
・Wick (1)
・Wick (10)
・Felt presser assembly (7) in "6-6. Needle
bar mechanism (2)"
・Wick (11) in "6-3. Zigzag mechanism"
1032B
1033B
1034B