Brother RH-9820 Service Manual page 86

6. ASSEMBLY
G
1) Tie the wick (75) around the wick release plate (78) as shown in the illustration.
* Make a double knot in the wick, and then set the wick so that the distance from the knot to the end is
as shown in the illustration, and cut off any excess length.
2) Install the felt (76) to the wick release plate (78) with the two cable ties (77).
* Cut the ends of the two cable ties (77) so that a length of 0 to 2 mm remains.
(Viewed from the front)
H
Pass the wick (9) and the wick (75) through the
oil tube (79) as shown in the illustration, and
then pass them through the hole (f).
77
(Viewed from the right)
I
Push the five wicks (g) into the hole (h) as
shown in the illustration, and then install the
cord presser (80) and secure it by tightening
the screw (81).
1187B
RH-9820
1186B
1188B