Management Parameters (P3.) - Adtech ADT-CNC4620 Maintenance Manual

Adtech CNC Technology Co., Ltd.
Range
Unit
Authority
Default
Effective time
Note

11.4 Management parameters (P3.)

001 Select SupMode
002 AlterSuperuserPasswor
003 Alter User Password
Range
Unit
Authority
Default
Effective time
Note
004
Initialize
005
Initialize IO Config
006
all para reset<●>
Range
Unit
Authority
Default
Effective time
Note
: 1~90000
:
: Super Admin
: 90000
: Instant
: Used to configure the restriction acceleration of every axis during
pretreatment processing.
No matter which parameter, the lower the setting is, the slower the
processing speed is; vice versa.
The setting value should be as high as possible if each axis permits.
In comprehensive parameter P1.58 (interpolation speed mode), this
parameter is valid if it is set to 1; the default setting is invalid.
: None
: None
: None
: None
: Instant
: In this menu, type the password and press 'Insert'. If the password is
valid, the system will enter this user mode;
After entering, this menu will turn into "Exit XXX admin mode",
indicating entering successfully;
In the new menu, press the Insert key to exit the admin mode. To modify
the parameter table at this moment, you need to enter the admin mode
again;
The super user can modify all passwords, while the operation user only
can modify the own password.
Password 0 indicates that the password isn't checked in this mode; it isn't
required to enter the admin mode to modify the parameters.
: None
: None
: Super user
: None
: Instant
: Initial parameter table only in super user mode
11. System parameters
- 69 -