Adtech ADT-CNC4620 Maintenance Manual page 61

Adtech CNC Technology Co., Ltd.
Effective time
Note
059 GCode pre-treatment
Range
Unit
Authority
Default
Effective time
Note
060 'O'Pro Scan
Range
Unit
Authority
Default
Effective time
Note
061 SpindleControlMode
Range
Unit
Authority
Default
Effective time
Note
062 X ZeroReturn Speed
063 Y ZeroReturn Speed
064 Z ZeroReturn Speed
065 4 ZeroReturn Speed
Range
Unit
Authority
Default
Effective time
Note
066 Safe Signal ELevel
Range
: Instant
: In pretreatment mode, set to 0 to use corner speed balancing algorithm,
or set to 1 to use axis acceleration constraints balancing algorithm
: 0~1
: None
: Operation admin or higher
: 0 (real-time processing)
: Instant
: Real-time processing is suitable for machine test.
In pretreatment mode, the system enters processing state buffs for two
seconds and pre-reads. The pretreatment mode only can check the
direction and size of feeding segment to adjust the speed automatically
and process at optimized speed.
: 0~1
: None
: Operation admin or higher
: 1
: Instant
: File scanning symbol will quicken the file transfer speed when
processing large files.
When transferring NC files, the system needs to scan over to position
every program block. In this way, if the file only has one block and the
file size is very big, it will cause unnecessary waiting time. If this option
is closed, the system will exit after scanning the address of first block.
: 0~1
: None
: Operation admin or higher
: 0
: Instant
: Control mode corresponding to principal axis S code (frequency
conversion mode)
0: Analog output
1: Section speed regulation (4-digit code), as below:
OUT23------S0
OUT22------S1
OUT21------S2
OUT20------S3
In analog output mode, the analog voltage is:
V=S/MaxRPM
S is the rotation set by the user, and MaxRPM is the maximum rotation
of principal axis set by the parameter (P4.017);
In switching quantity mode, constitute block 0-15 according to four-digit
code to output; S code value is restricted to 0-15;
: 0~9999
: mm/min
: Operation admin or higher
: 1000
: Instant
: Set the home speed of every axis separately
: 0~1
11. System parameters
- 57 -