Setting Top-Of-Form - Reverse Paper Motion; Paper Stacking (Floor Cabinet Model); Operation (Continued); Paper Stacking (Floor Cabinet Models) - Printronix P3000 Series User's Reference Manual

Setting Top–of–Form – Reverse Paper Motion
NOTE: Do not use this method of setting top–of–form for heavy forms or peel–off label
forms.
1. Place the printer off line and raise the printer cover.
2. Move the Forms Thickness Adjustment Lever to the fully open position. (The CHECK indicator
lights, the status lamps flash alternately, and FAULT CONDITION PLATEN OPEN display.)
3. Rotate the Vertical Position Knob (on the right side of the printer) to align the first print line with
the top–of–form alignment indicator on the left tractor gate (Figure 2–5).
NOTE: Be sure there is enough paper extending through the tractor area so that forms do
not run out of the tractors during the reverse feed in the following step.
4. Press and release the CLEAR and PAPER ADV switches simultaneously. The paper reverses
feed to the top–of
5. Close the Forms Thickness Adjustment Lever to the appropriate paper thickness position.
6. Press the CLEAR switch to clear the PLATEN OPEN fault condition.
7. Close the printer cover and place the printer on line.

Paper Stacking (Floor Cabinet Model)

NOTE: The following paper stacking instructions pertain to the floor cabinet model printer
only. For pedestal models, refer to the paper stacking instructions accompanying your pa-
per basket/stacking kit.
The floor cabinet model printer can stack at least half a box of standard computer paper when the paper
is properly loaded. After loading the paper, perform the following steps.
1. Open the rear cabinet door to access the paper stacking area.
2. Advance the paper until a few sheets begin to stack on the floor of the printer cabinet.
3. Verify the following and make any necessary adjustments.
a. The paper perforation folds are folding naturally.
b. The paper is following a straight path down to the paper stack.
4. Run the printer and stack approximately 15 to 20 sheets of paper.
5. Repeat step 3. Any adjustments to the paper stack can be made while the printer is running. If an
adjustment is made, check the stack again after approximately 15 to 20 sheets have been proc-
essed.
2–14
–
form position on the current form.
Operation