Line Spacing 1/6 Inch - Printronix P3000 Series User's Reference Manual

Line Spacing 1/6 Inch

P–Series
Serial
Purpose
Comment
Example
Programming
ASCII
SFCC LPI;n
SFCC 2
ESC 2
Sets line spacing to 6 lpi or as set by ESC A.
The value of n can only be 6 or 8. In P–Series protocol and LPI mode, if n = 6, this
command sets line spacing to 1/6 inch. Values of n other than 6 or 8 cause an error
message (Command Line Error Messages are listed on page 6–3).
SFCC/ESC 2 asserts n/72–inch line spacing as set by SFCC/ESC A (page 6–51). If
no distance has been set by SFCC/ESC A, the distance is 1/6 inch.
The control code line spacing selection overrides the control panel line spacing set-
ting.
The following example illustrates 1/6–inch line spacing and assumes that a distance
has not been set by ESC A.
Hex
SFCC 32
1B 32
Decimal
SFCC 50
27 50
6–47