Factory Default Configuration Values - Printronix P3000 Series User's Reference Manual

Factory Default Configuration Values

The printer comes with a set of Printronix factory configuration values, shown in Table 3–1. These
values are set at the factory, and are operational when the printer is received. New values can be saved
and applied as necessary for each application, but factory default values remain accessible using the
LOAD PARAMETERS configuration. On the Control Panel Configuration Diagram, factory configu-
ration values are indicated by a asterisk (
the Configuration Procedure on page 3–5 to change values of the configuration parameters for your
application.
Configuration
Parameter
Forms Length
Line Spacing
Print Mode
Select Set
Select Language
Select Subset
Printer Protocol
Printer Select
Paper Advance Switch
Power On State
Alarm On Fault
Unidirectional
Select SFCC
80–9F Hex
Control Code 08
Control Code 06
Overstrike
Auto Line Feed
Define CR Code
Define LF Code
VFU Select
Perforation Skip
Paper Empty
PMD Fault
Print Width
Host Interface
3–4
*
). (The asterisk is not shown on the printer display.) Refer to
Table 3–1. Printronix Factory Default Configuration Values
Factory Default
Value
11.0 Inches
6 lpi
DP 10 cpi
IBM PC
ASCII
IBM PC Graphics
P–Series
Disable
PRINT + PAP ADV
Online
Enable
Disable
01 SOH
Control Codes
Double High
8 lpi
Enable
After Full Line
CR = CR
LF = CR + LF
EVFU
00.0 Inch
End of Paper
Enable
13.2 Inches
Centronics
Configuration
Parameter
Parallel Interfaces:
Data Bit 8
Data Polarity
Resp. Polarity
PI Line
Strobe Polarity
Latch Data On
Serial RS–232 Interface:
Data Protocol
Data Rate
Word Length
Stop Bit
Parity
Bit 8 Function
CD AND CTS
DSR
Data Term Ready
Request to Send
Reverse Channel
Factory Default
Value
Enable
Standard
Standard
Disable
Standard
Leading Edge
X–On / X–Off
9600 Baud
8 Bits
One
None
Font Select
Disable
Disable
Online and BNF
Online and BNF
Online and BNF
Configuration