Line Spacing 8 Or 10.3 Lpi (One Line Only) - Printronix P3000 Series User's Reference Manual

Line Spacing 8 or 10.3 lpi (One Line Only)

P–Series
Serial
Purpose
Comment
Example
Programming
ASCII
ACK
SFCC f
N/A
Selects line spacing of 1/8 or 7/72 inch for the current line only.
The default line spacing is reselected automatically after one line. Select line spac-
ing either by the control panel 6/8 LPI switch or by line spacing control codes. The
control code setting overrides the setting on the display.
8 and 10.3 lpi spacing for one line applies only to P–Series programming compati-
bility.
If the alternate line spacing selected from the control panel is 8 lpi, the ACK control
code will set the line spacing to 8 lpi. If 10.3 lpi was selected from the control panel,
the ACK control code will set line spacing to 10.3 lpi (7/72 inch).
In Serial Matrix printer protocol, you can use this line spacing command for a single
line with ESC J (Line Feed n/216–Inch), where n=27 for 8 lpi, or n= 21 for 10.3 lpi,
and Line Feed = Newline.
In Serial Matrix compatible control code ESC 0 and P–Series SFCC 0 can be used
for continuous 1/8–inch line spacing.
The following example illustrates printing a single line of text at 8 lpi.
Hex
06
SFCC 66
N/A
Decimal
06
SFCC 102
N/A
6–49