Skip-Over Perforation - Printronix P3000 Series User's Reference Manual

Skip–Over Perforation
P–Series
Serial
Purpose
where
Comment
6–62
ASCII
N/A
ESC N n
Selects the number of lines (at the current line spacing) for the paper "skip" at the
bottom of the perforated page.
n = 1 to 127 to select the number of lines to skip. If the value of n exceeds the
current forms length, it is ignored.
The actual distance set is the product of n and the current line spacing. The factory
default value is to disable skip–over perforation. You can specify the default value.
Setting a new forms length (ESC C) resets skip–over perforation to zero.
This feature is disabled whenever vertical tabs are set.
You can also select skip–over perforation from the control panel; however, vertical
tabs within the skip–over perforation zone, as set by the control panel, are ignored.
The control code skip–over perforation setting from the host computer overrides the
control panel setting.
Hex
N/A
1B 4E n
Decimal
N/A
27 78 n
Programming