Line Spacing 1/8 Inch (8 Lpi) - Printronix P3000 Series User's Reference Manual

Line Spacing 1/8 Inch (8 lpi)

P–Series
Serial
Purpose
Comment
Example
6–48
ASCII
SFCC LPI;n
SFCC 0
ESC 0
Specifies continuous line spacing at 1/8–inch increments (8 lpi).
When the 1/8–inch line spacing control code is received, all lines are printed at 8 lpi
until a new line spacing is selected or the power is reset. The control code line spac-
ing selection overrides the control panel line spacing setting and 8 lpi is reflected on
the display when the 6/8 LPI switch is pressed.
The value of n can only be 6 or 8. When using SFCC LPI;n in the P–Series mode and
n = 8, this command sets line spacing to 1/8 inch. Values of n other than 6 or 8 cause
an error message (Command Line Error Messages are listed on page 6–3).
The following example illustrates 1/8–inch line spacing.
Hex
SFCC 30
1B 30
Decimal
SFCC 48
27 48
Programming