Checking The Configuration - Huawei AR530 series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
----End

2.6.1.6 Checking the Configuration

Procedure
l
l
l
----End
2.6.2 Configuring Link Aggregation in LACP Mode
Link aggregation implements load balancing, increases bandwidth, and improves transmission
reliability.
2.6.2.1 Creating an Eth-Trunk
Context
Eth-Trunks increase bandwidth and improve transmission reliability. You can configure Layer
2 and Layer 3 Eth-Trunks based on network applications.
Procedure
l
Issue 01 (2014-11-30)
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
3. Run:
load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-
mac }
A load balancing mode is configured for the Eth-Trunk.
By default, the load balancing mode of a Layer 3 Eth-Trunk is src-dst-ip.
Eth-Trunk member interfaces use flow-based load balancing. The local and remote
ends can use different load balancing modes, without affecting each other.
Run the display eth-trunk [ trunk-id [ interface interface-type interface-number |
verbose ] ] command to check the Eth-Trunk configuration.
Run the display trunkmembership eth-trunk trunk-id command to check information
about Eth-Trunk member interfaces.
Run the display trunk resource command to check Eth-Trunk resources that have been
used on a device.
Create a Layer 2 Eth-Trunk.
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
A Layer 2 Eth-Trunk is created.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
47