Checking The Configuration - Huawei AR530 series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Step 3 Run:
max bandwidth-affected-linknumber link-number
The maximum number of connections affecting the Eth-Trunk bandwidth is set.
By default, the maximum number of connections affecting the bandwidth of an Eth-Trunk is
8.
----End

6.6.2.5 Checking the Configuration

Procedure
l
----End
6.6.3 Setting RSTP Parameters that Affect RSTP Convergence
RSTP supports link type and fast transition configuration on ports to implement rapid
convergence.
Pre-configuration Tasks
Before configuring RSTP parameters that affect RSTP convergence, configure basic RSTP
functions.
6.6.3.1 Setting the RSTP Network Diameter
Context
Any two terminals on a switching network are connected through a specific path along multiple
devices. The network diameter is the maximum number of devices between any two terminals.
A larger network diameter indicates a larger network scale.
An improper network diameter may cause slow network convergence and affect communication.
Run the stp bridge-diameter command to set an appropriate network diameter based on the
network scale, which helps speed up convergence.
It is recommended that all devices be configured with the same network diameter.
Procedure
Step 1 Run:
Issue 01 (2014-11-30)
Run the display stp [ interface interface-type interface-number ] [ brief ] command to
view the spanning tree status and statistics.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 STP/RSTP Configuration
199