Setting The Lacp Mode - Huawei AR530 series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
l
----End

2.6.2.2 Setting the LACP Mode

Context
Link aggregation can work in manual load balancing mode or LACP mode depending on whether
LACP is used.
In LACP mode, you must manually create an Eth-Trunk and add interfaces to the Eth-Trunk.
However, LACP determines active interfaces through negotiation.
Before changing the working mode of an Eth-Trunk, ensure that the Eth-Trunk contains no
member interface.
Issue 01 (2014-11-30)
By default, an Eth-Trunk works in Layer 2 mode.
Create a Layer 3 Eth-Trunk.
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
A Layer 2 Eth-Trunk is created.
3. Run:
undo portswitch
The Eth-Trunk is configured to work in Layer 3 mode.
4. Run:
ip address ip-address { mask | mask-length } [ sub ]
An IP address is configured for the Layer 3 Eth-Trunk.
5. (Optional) Run:
mtu mtu
The maximum transmission unit (MTU) of the Eth-Trunk is set.
The default MTU of an interface is 1500 bytes.
NOTICE
l The mtu command cannot be used on Layer 2 Eth-Trunks.
l Directly connected interfaces must use the same MTU. If you change the MTU of
a local interface, you must use the mtu command to change the MTU of the remote
interface to be the same value; otherwise, services may be interrupted.
l After changing the MTU on an interface, run the shutdown command and then
the undo shutdown command on the interface to make the setting take effect.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
48