Default Settings - Huawei AR530 series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
Table 2-1 Configuration task summary of link aggregation
Item
Configure link aggregation in
manual load balancing mode.
Configure link aggregation in
LACP mode.

2.5 Default Settings

This section describes default parameter settings of link aggregation.
Table 2-2 Default parameter settings of link aggregation
Parameter
Link aggregation mode
Upper threshold for the number of active
member links
Lower threshold for the number of active
member links
LACP system priority
LACP interface priority
LACP preemption
LACP preemption delay
Timeout interval at which LACPDUs are
received
Issue 01 (2014-11-30)
Description
In manual load balancing
mode, you must manually
create an Eth-Trunk and add
member interfaces to the Eth-
Trunk. All active links
forward data and evenly load
balance traffic. The manual
load balancing mode is often
used when the remote device
does not support LACP.
In LACP mode, you must
manually create an Eth-
Trunk and add interfaces to
the Eth-Trunk. LACP
determines active interfaces
by negotiating parameters in
LACPDUs. LACP provides
backup links and ensures
high reliability of member
links
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
Task
2.6.1 Configuring Link
Aggregation in Manual
Load Balancing Mode
2.6.2 Configuring Link
Aggregation in LACP
Mode
Value
Manual load balancing mode
8
1
32768
32768
Disabled
30s
90s
41