Checking The Configuration - Huawei AR530 series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching

9.6.3.7 Checking the Configuration

Prerequisites
The configurations for remote bridging are complete.
Procedure
l
l
----End
9.6.4 Configuring Remote Bridging Integrated with IP Routing
Configuring remote bridging integrated with IP routing allows users in different geographical
locations and on different network segments to communicate with each other.
9.6.4.1 Creating a Bridge Group
Context
A bridge group is a virtual group. It can forward packets only after interfaces have been added
to the group.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
A bridge group is created and the bridge group view is displayed.
If the bridge group specified by bridge-id exists, the bridge group view is displayed.
Multiple devices can use the same bridge number.
----End
9.6.4.2 Adding a LAN-side Interface to a Bridge Group
Context
A bridge group is a virtual group. It can forward packets only after interfaces have been added
to the group.
As shown in
Issue 01 (2014-11-30)
Run the display bridge [ bridge-id ] information command to view information about the
bridge group.
Run the display bridge traffic [ bridge bridge-id | interface interface-type interface-
number ] command to view the traffic statistics on a specified interface in the bridge group.
Figure 9-17, the following methods can be used to add users to a bridge group:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Transparent Bridging Configuration
373