Huawei AR530 series Configuration Manual page 132

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
Step 5 Check whether port isolation is configured.
Run the interface interface-type interface-number command in the system view to enter the
interface view, and then run the display this command to check whether port isolation is
configured on the interface.
l If port isolation is not configured, go to
l If port isolation is configured, run the undo port-isolate enable command on the interface
Step 6 Check whether correct static Address Resolution Protocol (ARP) entries are configured on the
user terminals. If the static ARP entries are incorrect, modify them.
----End
Issue 01 (2014-11-30)
Check Item Method
Whether the Run the display vlan vlan-id command in any view to check whether
interfaces are the VLAN contains the interfaces. If not, add the interfaces to the
added to the VLAN.
VLAN
NOTE
l Add an access interface to the VLAN using either of the
l Add a trunk interface to the VLAN.
l Add a hybrid interface to the VLAN using either of the following
Whether Check the connections between interfaces and user terminals
connections according to the network plan. If any user terminal is connected to
between interfaces an incorrect interface, connect it to the correct interface.
and user terminals
are correct
After the preceding operations, if the MAC address entries are correct, go to
to disable port isolation. If the fault persists, go to
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
If the interfaces are located on different devices, add the interfaces connecting
the devices to the VLAN.
The default type of an Router interface is Hybrid. You can run the port link-
type command to change the interface type.
following methods:
1. Run the port default vlan command in the interface view.
2. Run the port command in the VLAN view.
Run the port trunk allow-pass vlan command in the interface
view.
methods:
1. Run the port hybrid tagged vlan command in the interface
view.
2. Run the port hybrid untagged vlan command in the
interface view.
Step 6.
3 VLAN Configuration
Step 6.
Step 5.
118