Authorized Repair Service - Cardiac Science Powerheart G3 Plus 9390E Operator's And Service Manual

Authorized Repair Service

The AED has no user-serviceable internal components. Try to resolve any
maintenance issues with the AED by using the Troubleshooting Table
presented in this chapter. If you are unable to resolve the problem, contact
Cardiac Science Customer Service (See Contact Information on page 1-1) or
contact your local Cardiac Science distributor.
WARNING: Shock Hazard.
!
Do not disassemble the AED. Failure to observe this warning can result in
personal injury or death. Refer maintenance issues to Cardiac Science authorized
service personnel.
Note: The warranty will be void upon unauthorized disassembly or service
of the AED.
Frequently Asked Questions
Q: Can I give CPR while the AED is analyzing?
A: No. As with all AEDs, the operator should stop CPR compressions during
the analysis phase.
Q: Can I transport the victim while the AED is analyzing?
A. No. Vehicle motion may cause noise artifacts that could interfere with
proper cardiac rhythm analysis. Stop the vehicle when cardiac rhythm
analysis is necessary.
Q: Do I need to prepare the chest prior to pad application?
A: Special preparation is not usually necessary. The chest should be as clean,
dry, and as oil free as possible. Follow your Medical Director's instruction.
Q: What happens if the battery is low when I begin a rescue?
A: When the battery indicator is red, the AED issues a "Battery Low"
prompt once; however, the AED is still capable of delivering approximately 9
more defibrillation shocks.
When the AED is not capable of delivering any more shocks, it "beeps" once
every 30 seconds.
To continue the rescue attempt, leave the lid open and replace the battery.
When the battery replacement takes longer than 60 seconds, the first rescue
Version 112-2025-109 B Maintenance and Troubleshooting 6-5