Authorized Repair Service - Cardiac Science POWER2HEART AED G3 Automatic 9300A Operation And Service Manual

Check the Integrity of the Service Indicator (LED) and Circuitry
1. Immediately after opening the AED lid, press and hold the SHOCK/CONTINUE
button and confirm that the SERVICE LED is lit.
2. Release the SHOCK/CONTINUE button.
3. Close the lid.
4. Verify that the STATUS INDICATOR remains red, (for Powerheart AED only).
5. Open the lid and confirm that no diagnostic indicators are lit.
6. Close the lid.
7. Verify that the STATUS INDICATOR turns green.
Check the Integrity of the Case
Examine the molded case of the AED for any visible signs of stress. If the case shows signs of stress, contact
Cardiac Science Customer Service at one of the following telephone numbers: (888) 466-8686, +45.4438.0539
outside the U.S. and Canada, or contact your local Cardiac Science distributor.
CAUTION: Case Cleaning Solutions
When disinfecting the case, use a non-oxidizing disinfectant, such as ammonium salts or a
glutaraldehyde based cleaning solution, to avoid damage to the metal connectors.

AUTHORIZED REPAIR SERVICE

The AED has no user-serviceable internal components. Try to resolve any maintenance issues with the AED by
using the Troubleshooting Table presented in this chapter. If you are unable to resolve the problem, contact
Cardiac Science Customer Service for repair information at one of the following telephone numbers:
(888) 466-8686, +45.4438.0539 outside the U.S. and Canada, or contact your local Cardiac Science distributor.
WARNING: Shock Hazard
Do not disassemble the AED! Failure to observe this warning can result in personal
injury or death. Refer maintenance issues to Cardiac Science authorized service personnel.
Note: The warranty will be void upon unauthorized disassembly or service of the AED.
page 44 112-2025-005 Rev B © 2003-2004 Cardiac Science, Inc. All rights reserved.