Chapter 2 Hardware Installation; Physical Setup For Compex Cgx3224; Desktop Installation; Rack-Mounted Installation - Compex CGX3224 User Manual

Chapter 2 Hardware Installation
Chapter 2 Hardware Installation
This chapter gives an overview on the hardware installation, from installing the physical cables
to resetting the device.
2.1

Physical Setup for Compex CGX3224

Compex CGX3224 is ideally suitable for office environment usage, which can be either
installed on a flat surface or mounted on a 19-inch rack. The following steps illustrate
how a proper installation is done.
2.1.1

Desktop Installation

1. Unpack Compex CGX3224.
2. Remove the backing strip from the 4 rubber feet and attach to the
underside of the switch chassis firmly.
3. Place it near a power outlet. Please put the device in the position that
would allow sufficient space for heat ventilation.
4. The surface to place Compex CGX3224 should be clean, smooth, level
and sturdy.
5. Ensure there is enough space around the unit to allow the attachment of
network cables.
6. Connect the power cord to the power socket on the rear panel of Compex
CGX3224.
2.1.2

Rack-Mounted Installation

1. Position one bracket to align with the holes on one side of Compex
CGX3224 and secure it with the smaller bracket screws (1/8-inch
diameter). Then attach the other bracket to another side of it.
2. After attaching both mounting brackets, position the device in the rack by
lining up the holes in the brackets with the appropriate holes on the rack.
Secure it to the rack using the rack-mounting screws (5/16 inches
diameters) and a screwdriver.
7