D Igital I Nputs - GE Multilin 469 Instruction Manual

CHAPTER 6: ACTUAL VALUES
6.2.5 Start Blocks
START
BLOCKS
6.2.6 Digital Inputs
DIGITAL
]
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
PATH: ACTUAL VALUES
[ ]
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
Any active blocking functions may be viewed here. The
message is seen only if the Phase CT Primary or Motor FLA settings have not been
programmed.
PATH: ACTUAL VALUES
[
INPUTS
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
A1 STATUS START BLOCKS
NO START BLOCKS
ACTIVE
OVERLOAD LOCKOUT
BLOCK: 25 min.
START INHIBIT
BLOCK
STARTS/HOUR BLOCK
LOCKOUT TIME: 20
TIME BETWEEN
STARTS
RESTART BLOCK
LOCKOUT: 1200 s
WARNING
469 NOT PROGRAMMED
A1 STATUS DIGITAL INPUTS
ACCESS
SWITCH STATE:
Open
TEST
SWITCH STATE:
STARTER STATUS
SWITCH STATE:
EMERGENCY RESTART
SWITCH STATE:
REMOTE RESET
SWITCH STATE:
ASSIGNABLE DIGI-
TAL
ASSIGNABLE DIGI-
TAL
ASSIGNABLE DIGI-
TAL
Range: N/A. Message seen when no
start blocks are active
Note: Message seen only after an
overload trip
Range: 0 to 500 min.
Range: 0 to 60 min.
Range: 0 to 500 min.
Range: 0 to 50000 sec.
Note: Seen only if Phase CT Primary
or Motor FLA not programmed
WARNING 469 NOT PROGRAMMED
Range: Open, Shorted
Range: Open, Shorted
Range: Open, Shorted
Range: Open, Shorted
Range: Open, Shorted
Range: Open, Shorted
Range: Open, Shorted
Range: Open, Shorted
6–9