P Asscode - GE Multilin 469 Instruction Manual

5.2 S1 469 Setup
5.2.1 Passcode
PASSCODE
5–8
PATH: SETTINGS S1 469 SETUP
[
MESSAGE
MESSAGE
A passcode access security feature is provided in addition to the settings access jumper.
When shipped from the factory, the passcode is defaulted to 0. Passcode protection is
ignored when the passcode is 0. In this case, only the settings access jumper is required for
changing settings from the front panel. Passcodes are also ignored when programming
settings via the RS485 port. However when programming settings using the front RS232
port and the EnerVista 469 Setup software, a passcode is required (if enabled).
The
ENTER PASSCODE FOR ACCESS
is "Restricted". The
SETTINGS ACCESS
seen only if the passcode is 0 and the
To enable passcode protection on a new relay, follow the procedure below:
1. Press MESSAGE then MESSAGE
2. Select "Yes" and follow the directions to enter a new passcode 1 to 8 digits in
length.
3. Once a passcode (other than "0") is programmed, it must be entered each time
settings access is restricted. If a non-zero passcode has been programmed and
settings access is restricted, then the
appears when entering the
4. Enter the correct passcode. A flash message will advise if the code is incorrect
and allows a retry. If the passcode is correct and the settings access jumper is
installed, the
settings ACCESS: Permitted
5. settings can now be entered. Press ESCAPE to exit the
group and program the appropriate settings. If no keys are pressed for 5 min-
utes, programming access will no longer be allowed and the passcode must be
re-entered. Removing the settings access jumper or setting the
settings to "Restricted" will also immediately disable settings access.
If a new passcode is required, gain settings access by entering the valid passcode as
described above, then press
and follow directions. If an invalid passcode is entered, an encrypted passcode may be
viewed by pressing the
HELP
if the currently programmed passcode is unknown. Using a deciphering program, the
passcode can be determined.
PASSCODE
ENTER PASSCODE
FOR
settings ACCESS:
Permitted
CHANGE PASSWORD:
No
settings is seen only if the passcode is not 0 and
SETTINGS ACCESS
SETTINGS ACCESS
until
CHANGE PASSCODE?
ENTER PASSCODE FOR ACCESS
S1 469 SETUP PASSCODE
message appears.
to display the
MESSAGE
key. Consult the factory service department with this number
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
Range: 1 to 8 numeric digits
Range: Permitted, Restricted
Range: No, Yes
and settings are
CHANGE PASSWORD
is "Permitted".
is displayed.
subgroup.
S1 469 SETUP
SETTINGS ACCESS
message
CHANGE PASSCODE
message
PASSCODE