Setting The Offload Position - 3D Systems ProX 800 User Manual

Setting the Offload Position

If the Manual Offload needs to be adjusted, you can do so by following these steps:
1. Select Edit from Move
ProX 800
1. The editing keypad pops up. Type in the amount to move (ex. ".5" will move print pad up ½"). This is a good place to start.
2. Press Set.
3. Repeat these steps until the print pad is far enough up to get the Manual Offload Cart under it without damaging the
recoater or to reach the timing plate. Refer to the section,
NOTE: If the print pad is too high, you can reverse it by typing
set a negative value . This moves the print pad down ½" .
ProX 800
3D Systems, Inc.
Distance.
"To Remove a Part," on page 62
.5 > - (minus sign) > Set
54
.
in the editing keypad to