INSTALLATION OF PRINT PLATFORM WITH OFFLOAD CART
Verify that the MDM is installed in the printer before starting this process. Wear nitrile gloves when handling the print pad to
prevent material exposure to your skin.
1. Verify that the elevator is at its offload position. If necessary, move it to its offload position by selecting
Move to Offload
the
button on the
NOTE: If this is right after a build, you may get the warning message, "Print applicator is not
at home position ." If so, press
2. Lower the print platform onto the elevator forks by pulling lever on the offload cart down.
3. Perform steps 2-5 on the previous page.
Pull adjustment lever down
3D Systems, Inc.
Elevator/Leveler
screen under the
Print Applicator > Move to Home .
61
Tools
menu.