Table of Contents
Advertisement
PRINT APPLICATOR SCREEN
The Print Applicator Screen allows you to operate the print applicator manually.
A
A
Manual Motions:
Move to Home:
home position.
Move:
To manually move the print applicator:
•
Set the
Move Distance
desired value by using the edit button
•
When these values are satisfactory, press the
Move
button to activate manual motion.
Vacuum OFF:
on and off.
Remove Bubbles:
remove bubbles on the material surface.
Print Applicator Calibration:
operation to calibrate the print applicator system.
Stop:
Stops the current manual motion and
operation.
Forward:
Manually move the print applicator
towards the front of the system. Press and hold to
move.
Rear:
Manually move the print applicator to the
rear of the system. Press and hold to move.
Reset Home:
This recalibrates the home position
of the applicator. This will need to be used if the
motor of the print applicator blade gets out of
sync.
Allow Motion / Motion Not Allowed:
message pops up when you open the screen.
It indicates whether or not the system is in a
3D Systems, Inc.
Move the print applicator to its
and
Velocity
Switch the print applicator vacuum
Runs a predefined operation to
Runs a predefined
This
state where the print applicator can be operated
manually. To operate the print applicator, the
elevator must be at least 2 inches below the
surface of the print material and the applicator
must not be able to collide with the elevator. This
can usually be accomplished by pressing the
to Home
to the
NOTE: If the Start Position has inadvertently
been set to a distance that is not at least 2
inches below the print material surface, the
Start Position must be changed so that
Home
"Printing a Part" on page 56
setting the Set Start Position .
B
Parameters:
Current Position:
the print applicator relative to the home position.
Move Distance:
print applicator. Set this value using the edit
button
Velocity:
inches per second, during manual motion. This
setting does not affect the applicator speed during
printing. Set this value using the edit button
C
Back:
Navigate back to the
page
32.
34
button on the
Elevator/Leveler
will go to the proper location . See
for instructions on
Shows the current position of
Amount to manually move the
Specifies the print applicator speed, in
"Tools Menu Screen" on
C
B
Move
Screen.
Move to
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
