3D Systems ProX 800 User Manual page 55

2. The editing keypad pops up. Type in the amount to move (ex. ".5" will move print pad up ½"). This is a good place to start.
3. Press Set.
4. Repeat these steps until the print pad is far enough up to get the Manual Offload Cart under it without damaging the
recoater or to reach the timing plate. Refer to the sections
Pad Removal" on page 50.
NOTE: If the print pad is too high, you can reverse it by typing
set a negative value . This moves the print pad down ½" .
5. Select Set Offload (1).
NOTE: This position will now be saved and can be used from now on by selecting
ProX 800
2
3D Systems, Inc.
"Remove a Part Without Offload Cart" on page 62
.5 > - (minus sign) > Set
1
55
and "Print
in the editing keypad to
Move to Offload (2) .