Setting The Offload Position - 3D Systems ProX 950 User Manual

Setting the Offload Position

If the Manual Offload needs to be adjusted you can do so by following these steps:
Edit
1. Select from
2. Editing keypad pops up. Type in amount to move (ex. .5 will
move platform up 1/2 inch), this is a good place to start.
3. Click Set
4. Repeat these steps until platform is far enough up to get
Manual Offload Cart under it without damaging recoater.
NOTE: If platform is too high you can reverse it by
typing .5 > - > Set
platform down 1/2 inch .
5. Select Set Offload (1).
6. Repeat Steps 3-5 of To Remove a
NOTE: This position will now be saved and can be used
from now on by selecting
3D Systems, Inc.
Move Distance.
in the editing keypad . This moves
Part.
Move to Offload (2) .
2
17
1