Table of Contents
Advertisement
15
IP
Misc
Artist's Monitoring
Matrix has an additional output for the artist's headphones, which is controlled by the
section, to the right of the
the artist's monitoring. The sources available are (from bottom to top) the
the
CUE
bus, the desk's
(EXT1). Each button lights to indicate which is active.
Note that while the other buttons light yellow, the
Normally these buttons cancel each other. However, the summing button (Σ Σ ) located immediately above the five source selector
buttons, removes the intercancelling feature and instead sums all selected inputs, enabling multiple sources to be monitored
simultaneously. Deselecting the Σ Σ button cancels all monitoring sources and returns the artist's monitor to intercancelling mode.
The
ARTIST MONITOR
and Total Recall LEDs. This is located in the top right of the
be switched into the circuit by pressing the
Both EQ pots are indented in the centre.
The pot in the bottom right is a gain control for the artist monitor output. The
above it reduces the feed to mono.
Engineer's Headphones
There is an engineer's headphone output located in the trim on the right hand side of Matrix, close
to the large navigation wheel. It is controlled by the area above the transport counter, consisting
of a
HEADPHONE
from the control room monitor mix to the artist's monitor mix (see above). The button lights to
indicate that the feed has been switched to the artist's mix.
While the
FROM ARTIST
selection in the
MAIN MONITOR
affected by the DIM, CUT,
Conversely, when
FROM ARTIST
selection,
EQ
insert and
11
12
T T a a l l k k b b a a c c k k
The engineer can talk to the artist by pressing and holding the
navigation wheel in the centre section. This sends the signal from the desk's inbuilt talkback microphone to the
artist's monitor feed.
ARTIST
The talkback microphone is located above the
(shown right). Its level is set by the
DIM
Note that the talkback function can also be assigned one of the two rear panel foot switch inputs via the
tab in the Matrix Remote. See Page 90 for more details.
Note also that the talkback does not feed the engineer's headphone signal, even when the
been selected.
16
MAIN MONITOR
DIGITAL
external monitor input (see Page 44), and the first of the two analogue external monitor inputs
has available a 2-band EQ with high-pass and low-pass shelving controls
EQ
gain pot and a
FROM ARTIST
button is not selected, the headphone signal follows the source
area, along with the
MINI
or level controls.
is selected, the engineer's headphone signal follows the
MONO
button, but is not affected by the level control.
13
14
function is automatically activated in the main monitoring.
LEFT
controls. The six buttons on the left hand side select the signal which is feeding
MON
bus lights green in keeping with its colour coding.
ARTIST MONITOR
button located in between the
button which switches the headphone feed
DIM
øL
and
MONO
15
16
MAIN MONITOR
TB
gain trim immediately above it. When it is pressed, the
Mon
Projec
Chapter 3 - Analogue Signal Flow
ARTIST MONITOR
MIX
bus, the control room monitor output (MON),
area, and can
HF
and
LF
pots.
iJack
MONO
button
CUT
buttons, but is not
ARTIST MONITOR
i
n
ARTIST
button located to the left of the large
area of the centre section
Me e
t rs
t 2 :: T
FROM ARTIST
Matrix Owner's Manual
RIGHT
area of the centre
iJack
MIX
REC
LEFT
source
62
2 2
Auto
TR
itle
DAW
button has
39
So
MO
1
I
iJack
Advertisement
Table of Contents
Need help?
Do you have a question about the Matrix and is the answer not in the manual?