Solid State Logic Matrix Owner's Manual page 146

Appendix G - Service
2 2 0 0 - - 6 6 2 2 9 9 5 5 1 1 2 2 X X 1 1 C C / / S S L L C C D D M M e e t t e e r r s s R R e e p p l l a a c c e e m m e e n n t t
• Follow instruction #2 for removal of the rear connector panel.
• Remove looms AA and Q from the meter assembly.
• Note that looms AA and Q use a Picoflex connector. To remove this connector grip the connector body firmly and pull
directly away from the assembly, pulling the connector at an angle may damage the plastic locating pins.
• Remove the four nuts holding the assembly in place using a 5.5mm spanner or nut spinner.
• Fit the replacement assembly and reassemble.
Matrix Owner's Manual
138