Programming Procedure - NEC UNIVERGE SV8300 System Maintenance Manual

Programming Procedure

The following explains the procedures for command operation from PCPro/CAT.
• CME4 Y=00 (Readout service status A for each station)
E400
X~XXXXXXXX
(Station Number)
• CME4 Y=01 (Readout service status B for each station)
E401
X~XXXXXXXX
(Station Number)
ST COMMAND=
+ DE E400>
+ DE X~XXXXXXXX : a b c d e f g h
ST COMMAND=
+ DE E401>
+ DE X~XXXXXXXX : i j k l m n o
Chapter 1 MAINTENANCE SERVICES
STATION SERVICE STATUS DISPLAY
Station Number
a : Terminal connection status
b : Make Busy
c : Line status
d : Call Forwarding-All Calls
e : Call Forwarding-Busy Line
f : Call Forwarding-No Answer
g : Logout/Call Forwarding-PS out of cell (zone)
h : Do Not Disturb
For details of abcdefgh, refer to Table A
(Readout Service Status A for Each Station).
Page 1-50
Station Number
i : Mobility access (Station Access/Call Forwarding)
j : Day/Night mode change
k : Number Sharing
l : Split Call Forwarding-All Calls
m : Split Call Forwarding-Busy Line/No Answer
n : ACD/UCD Busy Out
o : Outgoing Call Restriction
For details of ijklmno, refer to Table B
(Readout Service Status B for Each Station).
Page 1-51
1-49
NWA-033627-001 Rev.4.0
95ch1001.fm
JULY/17/2009