Messages; Storage - Honda HRM3000 Owner's Manual

Messages

If any of the following messages appear in the display, use this troubleshooting guide to address the
problem before contacting your dealer. If the problem persists, contact your dealer.
Message
Area signal lost The lawnmower does not detect the
boundary wire signal.
Battery capacity The battery does not charge enough.
low
Battery capacity The battery does not charge enough.
reduced
Battery temp
The battery temperature is too high.
high
Battery temp low (1) The battery temperature is too low.
Battery temp low (2)
Battery voltage
The battery charges too much.
high
Battery voltage The battery does not charge enough.
low
Blade motor The temperature of the blade motor is
or exceeds 85°C.
temp high
Clock reset
The backup battery power has drained
during long-term storage. The clock
has been reset.
ENT key The Enter button was pressed while
the lawnmower was running (with the
control panel cover closed).
Excessive tilt
The lawnmower is in an excessively
tilted area.
Key pad A button was pressed while the
lawnmower was running (with the
control panel cover closed).
Mower lifted
The cover has been lifted by
something, e.g. a stone.
Cutting height The height of the blade disc is off.
error
Cause
Check if the boundary wire connectors are
correctly connected. If the message does not
disappear, contact your dealer.
Increase the remaining capacity of homing. See
"Homing setup" (M page 46). If the message does
not disappear, contact your dealer.
Set the power to ON, and wait until the message
disappears.
If the message does not disappear, contact your
dealer.
Put the lawnmower in a place where the
temperature 5°C or higher, set the power to ON,
and wait until the message disappears.
If the message does not disappear, contact your
dealer.
Remove the lawnmower from the docking station,
set the power to ON, and wait until the message
disappears.
If the message does not disappear, contact your
dealer.
Charge the lawnmower with the docking station.
This message disappears if the battery is charged
more than 10%.
If the message does not disappear, contact your
dealer.
Leave the power ON and the control panel cover
open, and wait 15 to 30 minutes until the message
disappears. If the message does not disappear,
contact your dealer.
Set the current date and time. The time must be in
24-hour format.
If the clock cannot be set, contact your dealer.
Open the control panel cover and check if any
foreign objects are stuck inside.
If this message appears after removing any
foreign objects, contact your dealer.
Place the lawnmower on a fl at surface, and enter
the PIN so that the message disappears. If the
message does not disappear, contact your dealer.
Open the control panel cover and check if any
foreign objects are stuck inside.
If this message appears after removing any
foreign objects, contact your dealer.
Enter the PIN so that the message disappears.
If the cover is heavily damaged or the message
does not disappear, contact your dealer.
Refer to "Setting the height of the blades" (M page
67) and perform [Calibrate].
If the message does not disappear, contact your
dealer.
Messages
Solution
71