Usage; Checking The Mowing Area; Connecting To A Power Source - Honda HRM3000 Owner's Manual

6

USAGE

Checking the mowing area

Before operating the lawnmower, ensure the mowing area is free of
pets and foreign objects.
Turn off the lawnmower before removing any foreign objects.
CAUTION:
- If there are any holes (such as rabbit holes, etc.) in the work
area, fi ll them in so that the work area is level. Periodically
check the work area for holes.
Also confi rm that the height of the grass is 65 mm or less.
NOTE:
- Adjust the height of the blades to mow the grass within 5 mm. For
details on how to adjust the height of the blades, see "Setting the
height of the blades" (M page 67).
If the grass is taller than 65 mm, cut the grass using a standard lawnmower.

Connecting to a power source

Follow the steps below when connecting to a power source.
Follow these steps in reverse when disconnecting from a power source.
For details on moving the AC adapter or changing to a different power outlet, contact your dealer.
NOTE:
- Connect the station only to a supply circuit protected by a residual current device (RCD) with a tripping
current of not more than 30 mA.
Remove the station cover from the docking station.
1
If the power cord of the AC adapter is not long enough, connect the
2
extension cord.
Connect the power cord connector to the station's internal
connector.
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
- When the length of the cord is not enough even if you use an
extension cord, extend the power outlet (House) side.
Checking the mowing area / Connecting to a power source
65 mm or less
Power outlet (House) side
63