Honda HRM3000 Owner's Manual page 18

Installation
Installing boundary wire and connecting to the docking
station
Connector
16
Image
Boundary wire
–
Depth: 1 20 cm
Connector
Tab
Set the boundary wire by using the "LAWN
DIAGRAM" (M page 97).
• Leave enough wire to ensure that small
adjustments can be made, double backing
outside of the loop is acceptable.
• Do not fi x the wire until fi nish the layout.
• Boundary wire should be laid so that there is
no excess wire.
Peg
Fix the boundary wire with pegs to the specifi ed
depth as shown.
Attach a connector to both ends of the boundary
wire.
1. Put the boundary wire in the grip area of the
connector.
2. Press the connector click with a plier.
3. Cut the position of 1-2 cm from the each
connector.
The boundary wire must not be crossed when
connecting to the docking station.
The right hand wire end must be connected to
the right hand pin on the docking station and the
left hand wire end to the left pin.
1. Remove the station cover (M page 63).
2. Pass the boundary wire through the tabs.
3. Insert the connectors into the pins.
4. Install the station cover.
NOTE
- To connect the AC adapter to the docking
station, refer to page 63.
Operation