Replacing The Blades - Honda HRM3000 Owner's Manual

Replacing the blades

To replace the blades, perform the procedures below.
N WARNING
- Put on a pair of work gloves before performing the following procedures.
- Do not touch the blade while it is spinning. You may be injured if you do so.
NOTE:
- Before replacing the blades, remove the grass clippings (M page 76) .
- Use genuine parts or their equivalent for the blade.
Replacement Item(s)
Blade
Nut
Bolt
The blade holder is under the station cover of the docking station.
You can use the blade holder protrusion to remove debris such as grass or dirt that is stuck in the hole of
the bolts.
Set the cutting height to 20 mm (M page 67).
1
Turn the power off, and then turn the lawnmower
2
upside down.
Loosen the bolt with the hexagon wrench.
3
- The bolt is fastened with the nut. Be careful not to
excessively loosen the bolt because the nut may
fall off.
When the bolt is loose, hold the nut so that it does
4
not fall off, and remove the bolt.
Maintenance procedures
Part number
72511-VP7-030
90301-VP9-000
90101-VP9-000
Bolt
Nut
Blade
83