3.1 charging the battery
Before the first use, start by fully charging the battery.
120V ± 10%, 60Hz
230V ± 10%, 50Hz
3.2 operating the PEL
IMPORTANT: The following OPERATION instructions assume that the PEL has been configured by the user prior to
use. The PEL can only be configured through the PEL Control Panel distributed with the DataView
refer to § 4.3 for setup instructions.
1. The PEL must be first programmed before recording. This is done through the PEL Control Panel (see § 4.3). The PEL
103 cannot be programmed through the LCD and front panel. This is done to avoid inadvertent logging changes while
it is recording.
2. The PEL is then connected to a power supply and will turn on automatically (see § 3.3.1).
3. Recording is started by pressing the control button
4. The PEL can be turned OFF when disconnected from the power supply (and when the recording session is completed
- see § 3.3.2).
Power & Energy Logger Model PEL 102 and PEL 103
Find Quality Products Online at:
3. oPEration
■
Connect the supplied power cord to the instrument and AC power.
V1
V2
V3
N
I1
I2
I3
1000V CAT III
600V CAT IV
■
The device will automatically turn ON.
■
The
charged.
■
A low battery charging takes approximately 5 hours.
The Yellow/Red LED (see #6 Figure 8) is used to indicate the status of the
battery.
POWER & ENERGY LOGGER
ON /OFF
■
When the power is on, the battery is charging until it is full.
START/STOP
■
LED OFF: Battery full (with or without power supply)
■
Yellow LED ON/No blinks: Battery is charging
■
Yellow LED blinks twice per second: Battery is recovering after a full
discharge
■
Red LED blinks twice per second: Low battery (and no power supply)
GlobalTestSupply
www.
LED lights; it will go out only when the battery is fully
(see § 3.4).
.com
software. Please
®
sales@GlobalTestSupply.com
15