Led Status - AEMC PEL102 User Manual

2.11 LED status

LED & COLOR STATUS
Green LED: Recording Status
1
Blue LED: Bluetooth
2
Red LED: Phase Order
3
Red LED: Overload
4
Red/Green LED: SD-Card Status
5
Yellow/Red LED: Battery Status
6
Power & Energy Logger Model PEL 102 and PEL 103
Find Quality Products Online at:
ON /OFF
START/STOP
-
LED blinks once per second every 5 s: Logger in standby (not recording)
-
LED blinks twice per second every 5 s: Logger in recording mode
-
LED OFF: Bluetooth OFF (disabled)
-
LED ON: Bluetooth ON (enabled - not transmitting)
-
LED blinks twice per second: Bluetooth ON (enabled - transmitting)
-
OFF: Phase rotation order correct
-
LED blinks once per second: Phase rotation order incorrect
-
OFF: No input overload
-
LED blinks once per second: At least one input is in overload
-
LED ON: Indicates a current probe is either mismatched or missing
- Green LED ON: SD-Card is OK
-
Red LED blinks five times every 5 s: SD-Card is full
-
Red LED blinks four times every 5 s: less than 1 week capacity remaining
-
Red LED blinks three times every 5 s: less than 2 weeks capacity remaining
-
Red LED blinks twice every 5 s: less than 3 weeks capacity remaining
-
Red LED blinks once every 5 s: less than 4 weeks capacity remaining
-
Red LED ON: SD-Card is not present or locked
- When the AC power cord is connected, the battery charges until it is full.
- LED OFF: Battery full (with or without power supply)
-
Yellow LED ON: Battery is charging
- Yellow LED blinks once per second: Battery is recovering from a full discharge
-
Red LED blinks twice per second: Low battery (and no power supply)
GlobalTestSupply
www.
Figure 8
.com
1
2
3
4
5
6
7
8 9
sales@GlobalTestSupply.com
13