Select Preset Display; Cycles Since Last Filtered - Broaster 1600 Operation Manual

In any of these cases when the oil tempera-
ture reaches the set temperature the box
turns green indicating the oil is up to the set
temperature.
The temperature shown in this box can be
either the "Set" temperature of the "Actual"
temperature as indicated above the ther-
mometer. To change from one to the other
press anywhere in the box for 3 seconds.
An alert will sound when you press the box
and a second alert will sound when the
change is made.
To set the temperature, press the tempera-
ture box twice and a keypad will appear.
Enter the temperature for the product you
want to cook, as you enter the temperature,
it will appear above the keypad. To save this
temperature press the enter key.

Select Preset Display:

Select Preset
There are 2 "Select Preset" boxes.
All of the Broaster Company Products are
preloaded into the memory of the control
and can be selected when you want to
cook that product. The cook time and cook
temperature for that product will be auto-
matically entered in the Time and Tempera-
ture displays.
To select a product, press either preset box
and a menu of the products will be dis-
played. Tap the product you wish to select.
If the wrong product comes up, don't worry!
Tap the preset box again and the menu will
reappear.
When the item has been selected a picture
of the item will appear in the left box and a
description of the item will appear in the
right box. When a cook cycle is started the
left box turns yellow and the time remaining
in the cycle is displayed. The picture moves
to the right box.
If the menu item to be cooked uses a differ-
ent temperature the temperature box will
either remain green meaning it is all right to
start a cook cycle or it will turn yellow
meaning the temperature is too low to start
a load. Wait to start a cook cycle until the
temperature is green.
When the temperature is green. Load the
product as recommended and move the
small handle on the top of the fryer from
open to close. This will start the cycle timer
counting down. When the load is done an
alert will signal that the cooking cycle is
complete.

Cycles Since Last Filtered:

It is recommended the oil should be filtered
every 5 loads.
This box indicates how many cook cycles
have been completed since the last time
the oil was filtered. It is active and can be
pressed at any time to go to the filter dis-
play except during a cooking cycle. Once
you reach a preset number of cycles, you
will be shown a filter options screen. If a fil-
ter cycle is bypassed the next cycle will turn
red and start flashing.
This number can be changed and the pro-
cedure will be explained in the Setup Tab
section.
6-3
broaster.com Manual #17269 8/13 Rev 5/14
01
Cycles Since Last Filtered