Filtering - Broaster 1600 Operation Manual

FILTERING

Filter oil after cooking approximately 35 lbs.
(1600) or 65 lbs. (1800) of product, between
rush periods and always at the end of each
day. Filter oil at 360°F.
DO NOT
transport hot oil. Hot oil
could splash causing serious burns.
Be sure filter components are assembled
correctly. Correct order is (1) Filter Screen
on bottom of filter pan, (2) Filter Paper, (3)
Filter Hold Down, one cup (1600) or two
cups (1800) of Bro-Clean filtering media on
top of filter paper and/or 5 oz. (1600) or 10
oz. (1800) of XL filtering compound to cook-
ing well, and (4) Filter Cover. For best
results change paper after each filter cycle.
1. Be sure filter pan, with components, is
installed under unit properly. Make
sure O-ring is installed on (5) 1800
Riser Line or inside (5) 1600 Suction
Line. Ensure that riser line is fully
inserted into suction line.
use filter pan to
8-2
broaster.com Manual #17269 8/13 Rev 11/14
DO NOT
while the controller is dis-
playing the Cook Screen.
2. Using a ram rod, stir oil in a circular
motion. This will aid in draining
crumbs. Pull cover over cooking well
and open drain valve slowly. If valve
becomes obstructed with crumbs, use
ram rod to unblock valve.
DO NOT
point to hit bottom of fil-
ter pan. Point of ramrod can penetrate
filter paper allowing crumbs and filter
compound to pass through filter lines.
3. When oil is drained, pull cover over
cooking well completely but DO NOT
CLOSE. On the Filter Tab of the con-
troller, press the Start Pump button.
When oil is flowing out of drain, close
drain valve and pump approximately 4
inches (1600) or 8 inches (1800) of oil
into cooking well then press the Stop
Pump button.
4. Being careful of hot oil and cooking
well components, use bottom brush to
scrub cooking well starting at the top
and cleaning downward. On electric
units, clean inside and between heat-
ing elements. Use element brush to
clean between cooking well and heat-
ing elements. Be sure no crumbs
cover temperature sensor.
Temperature Sensor Location:
open drain valve
allow ramrod