Preset Cook Mode; Programming Method 1; Warning Displays - Broaster 2400 Series Service Manual

PRESET COOK MODE

PROGRAMMING METHOD 2
Select the temperature and time, following
the normal programming procedure. To
save these settings for a preset. Press and
hold the desired preset number for five sec-
onds until an audible beep is sounded.

WARNING DISPLAYS

HI - Display will flash HI if cooking oil tem-
perature exceeds 415
sound until cook/filter switch is turned OFF
or hi-limit trips. All controller functions and
heat source are disabled during this condi-
tion.
Cause: Faulty controller, gas valve
(2400GH Only) of contactor (2400E
Only).
PROB - Display will flash PROB if there is a
problem with temperature sensor probe.
Audible alert will sound until cook/filter
switch is turned OFF. All controller functions
and heat source are disabled during this
condition.
Cause: Temperature sensor prove
faulty, polarity of probe wires reversed
or probe wire(s) loose.
CHEC - Display will flash CHEC if cooking
oil temperature does not rise 6
first three minutes. Audible alert will sound
until cook/filter switch is turned OFF. All
controller functions and heat source are
disabled during this condition.
Cause: Faulty controller, heating ele-
ment(s) (2400E Only) gas valve
(2400GH Only), contactor (2400E
Only), probe or loose wiring.
°
F. Audible alert will
°
F within the
broaster.com Manual #15460 8/02 Rev 6/16
°
below 45 F. Turn cook/filter switch OFF
then to COOK for another three minute
heating period. This may have to be
repeated two or three times.
FAIL - Display will flash FAIL if controller
detects a fault within itself. Audible alert will
sound until cook/filter switch is turned OFF.
All controller functions and heat source are
disabled during this condition.
Cause: Faulty controller.
3-4
CHEC could appear if
cooking oil temperature is