1. Manuals
  2. Brands
  3. Directed Manuals
  4. Automobile Accessories
  5. DS4+
  6. Installation manual

Directed DIRECTECHS DS4+ Installation Manual

Hide thumbs Also See for DIRECTECHS DS4+:
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION GUIDE
SUBARU1
Designed by Installers for Installers
© 2017 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.
2017-03-07
DS4+

Advertisement

Table of Contents
loading

Related Manuals for Directed DIRECTECHS DS4+

Summary of Contents for Directed DIRECTECHS DS4+

  • Page 1 SUBARU1 Designed by Installers for Installers © 2017 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components.

  • Page 2: Table Of Contents

    Contents Warning! Safety first ........................3 Introduction ............................ 4 Pre-installation and application warnings ..................4 Vehicle application guide ......................5 Wiring connections ......................... 6 Main harness (H1), 12-pin black connector .................. 6 Relay harness (H2), 10-pin white connector .................. 6 Data harness (H3), 8-pin white connector ..................

  • Page 3: Warning! Safety First

    The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.

  • Page 4: Introduction

    LED Diagnostics & Troubleshooting section for more details. Additional parts required (maximum required): Resistor 100Ω Fuse 7.5A Diode 6A 0 x 1A Diodes 0 x Resistor 0 x Fuse 2 x Relay DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 5: Vehicle Application Guide

    DL: OE Door Lock & Alarm Controls FOB: Sync CAN Interface w/ FOB Remote PK: Transponder & Immobilizer Override RS: Remote Start & Engine Controls SS: Integrated Security & Monitoring ST: Function/Feature Status DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 6: Wiring Connections

    Orange/Black Immo. Data (vehicle side) H3/8 Yellow/Black Keyless Data (connector side) If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 7: Analog Input/Output Harness (H4), 22-Pin White Connector

    If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay may be necessary. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 8: Installation (Wiring Diagrams, Fuse Selection & Vehicle Wiring Reference Charts)

    It is important to check that the fuses are positioned correctly. See Refer to the Vehicle Wiring Reference Chart Fuse selection on the next page for on pages 9-10 for wire colors and location. more information. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 9 Ignition Switch, B72, at steering column. White Ignition 2 Blue Ignition Switch, B72, at steering column. White Starter White/Black Ignition Switch, B72, at steering column. White Parking lights Orange Parking Light Switch, B69, at steering column. White DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 10 Ignition Switch, B72, at steering column. White Ignition 2 Blue Ignition Switch, B72, at steering column. White Starter White/Black Ignition Switch, B72, at steering column. White Parking lights Orange Parking Light Switch, B69, at steering column. White DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 11 Ignition Switch, B72, at steering column. White Ignition 2 Blue Ignition Switch, B72, at steering column. White Starter White/Black Ignition Switch, B72, at steering column. White Parking lights Orange Parking Light Switch, B69, at steering column. White DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 12: Type 2

    It is important to check that the fuses are positioned correctly. See Refer to the Vehicle Wiring Reference Chart Fuse selection on the next page for on pages 12-13 for wire colors and location. more information. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 13 Ignition Switch, B72, at steering column. White Ignition 2 Blue Ignition Switch, B72, at steering column. White Starter White/Black Ignition Switch, B72, at steering column. White Parking lights Orange Parking Light Switch, B69, at steering column. White DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 14 Ignition Switch, B72, at steering column. White Ignition 2 Blue Ignition Switch, B72, at steering column. White Starter White/Black Ignition Switch, B72, at steering column. White Parking lights Orange Parking Light Switch, B69, at steering column. White DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 15: Type 3

    Fuse selection on the next page for more information. B281 - White 28-pin conn. Refer to the Vehicle Wiring Reference Chart (BCM, right of steering column) on pages 15-16 for wire colors and location. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 16 Ignition Switch, B72, at steering column. White Ignition Green Ignition Switch, B72, at steering column. White Starter 1 White/Black Ignition Switch, B72, at steering column. White Starter 2 White/Red Ignition Switch, B72, at steering column. White DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 17 Ignition Switch, B72, at steering column. White Ignition Green Ignition Switch, B72, at steering column. White Starter 1 White/Black Ignition Switch, B72, at steering column. White Starter 2 White/Red Ignition Switch, B72, at steering column. White DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 18: Key2Go

    Any first-time user must re-register to gain access to Key2GO, and some additional information will be required to complete the registration process, such as your Directed account number and store name. Key2GO is compatible with XKLoader2 and the online web tool, as well as XKLoader3 and the Directechs Mobile application.

  • Page 19: Adjusting The 8504D Shock Sensor

    All ports can be configured for D2D 1.0 and 2.0; however, if the device is not configured accordingly as well, it will not be recognized. • All ports need to be configured via the web, but the above is the recommended installation configuration. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 20: Module Programming

    By default, the tachometer is preprogrammed for the vehicle. For instructions on how to Initialize tachometer program tach, see page 24. * Your aftermarket remote may differ from the model shown in the illustrations. You have successfully completed the module programming sequence. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 21: Led Diagnostics And Troubleshooting

    Flashes red x 9 External module synchronization Description Troubleshooting OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. (Flashes red, red, then orange) x 10 DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.
  • Page 22 The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 Analog error codes Description Troubleshooting DEI feature error. A feature config file mismatch was detected. Please contact Technical Support. Flashes red, green & orange DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 23: Soft Reset

    After 3 seconds the LED turns ON solid orange. Keep holding the programming button until & & the LED flashes red, then orange slowly. Solid Hold Flashes Release the programming button. The LED turns ON solid red. & Release Solid DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 24: Learning The Tach (Not Needed With Virtual Tach)

    Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote start. Use the VirtualTach Fine tune feature in the configuration wizard to adjust the starter output time in 50mS increments to compensate for such an occurrence. DS4+ SUBARU1 © 2017-03-07 Directed. All rights reserved.

  • Page 25: Limited Lifetime Consumer Warranty

    Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...

  • Page 26: Quick Reference Guide

    Factory remote. Press the Remote Start button on the transmitter.* • Aftermarket remote. • Directed SmartStart application via your smartphone. & The parking lights will flash once to indicate the Parking lights flash x1 Press Remote vehicle is now in Pit Stop Mode.
  • Page 27 SmartStart compatible Notes This system is compatible with Directed SmartStart. For a complete list of supported features, please visit www.mysmartstart.com. What is SmartStart? Now you can remote start, lock and unlock your car just by pushing a button on your smartphone;...

Table of Contents