Snmp Settings - TRENDnet TEW-826DAP User Manual

TRENDnet User's Guide

SNMP Settings

Management > SNMP Settings
SNMP (Simple Network Management Protocol) is a network management protocol used
to monitor (read) and/or manage (write) multiple network devices on a network
through a preconfigured external SNMP server.
1. Log into your management page (see
8).
2. Click on the Management tab and click SNMP Settings.
3. Review the settings and click Save to save settings.

SNMP: Select enable to enable SNMP feature

Contact: Enter the contact person or contact information for your access
point.

Location: Enter an assigned location for your access point.

Community Name (Read only): Enter an assigned name for your access
point.

Community (Read/Write): Enter a public and private community name.

Trap Destination Address: Enter the destination IP address of the SNMP
trap.

Trap Destination Community Name: Enter the name of the destination
community
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access the management page" on page

SNMPv3: Select option to enable or disable SNMPv3

Username: Enter the username

Auth Protocol: Select from the pull down menu the authentication
protocol to use

Authentication Key: Enter the authentication key

Priv Protocol: Select the private protocol

Priv Key: Enter the private key

Engine ID: Enter the engine name
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
TEW-826DAP
45