Advertisement
English
NOTE:
This feature must be preprogrammed by a qualified
radio technician. Check with your dealer or system
administrator for more information.
Responding to the Notification of
Upgrade
1 The display shows Upgrade? and two short,
medium- pitched tones sound every 30 seconds until
the user makes a choice of either accepting,
delaying, or rejecting the request
2 Perform one of the following actions:
Press the Menu Select button below Acpt to
•
accept the request to upgrade immediately.
Press the Menu Select button below Dlay to
•
delay the request to upgrade.
Press the Menu Select button below Rej to reject
•
the request to upgrade.
One of the following scenarios occurs:
•
If you choose to accept, the display shows
Programming Dont power off to indicate the upgrade
176
is about to begin. The radio resets to install the upgrade.
In the case of configuration data upgrade, the process
only takes a few seconds. In the case of firmware
upgrade, the installation takes several minutes.
NOTE:
The radio cannot be used while the upgrade is
being installed. Therefore, make sure to only
accept the upgrade at a convenient time when
immediate radio use is not required.
•
If you choose to delay, a configuration data upgrade is
installed automatically at the next power up. However, in
the case of a firmware upgrade, the radio prompts
Upgrade? again at the next power up.
If you choose to reject, the display shows Upg Aborted.
•
The radio continues to function with the current
configuration until it gets reprogrammed.
NOTE:
If your radio has problems upgrading over-the-air,
consult a qualified technician for details.
Voice Announcement
This feature enables the radio to audibly indicate the
current feature mode, zone or channel the user has just
assigned. This audio indicator can be customized per
Send Feedback
Advertisement
