Disabling Transmit Inhibition; Impres Battery Annunciator - Motorola 3 User Manual

NOTE:
If the user has disabled TX Inhibit via the
menu and then moves the switch to the
position where TX Inhibit is enabled, the new
value overwrites the menu value.
The display shows Tx inhibit on. You hear a
sequence of short, low-high tones to indicate
transmission is inhibited.
Pressing PTT triggers the radio sounds a constant short,
low-pitched tone (reject tone).
NOTE:
The status of the Transmit Inhibit does not change
after the radio powers up.

Disabling Transmit Inhibition

Perform one of the following actions:
to TxIn. Press the Menu Select button
• or
below TxIn.
• Press the Transmit Inhibit programmable button.
Send Feedback
NOTE:
If the user has disabled TX Inhibit via the
softkey and then moves the switch to the
position where TX Inhibit is enabled, the new
value overwrites the menu value.
The display shows Tx inhibit off. You hear a
sequence of short, high-low tone (Transmit Inhibit
Off tone) to indicate transmission is back to normal
operation.

IMPRES Battery Annunciator

This feature displays the current capacity and charges
cycles of your battery when an IMPRES
powering your radio. This feature must be enabled in your
radio to see the information.
The information shown are:
Charge Percentage
Percentage of current battery capacity.
Remaining Capacity
Remaining power of the battery in mAh.
Estimated Charges
Number of charges cycles the battery has gone
through.
English
™
Battery is
195