Table of Contents
Advertisement
the upgrade pauses to give priorities to voice call, and
continues after the voice call ended. For Wi-Fi, the upgrade
process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio,
you can install new changes immediately or delay changes
to be installed on the radio when it is being powered up.
Your radio can also be configured to allow you to accept or
reject an upgrade.
NOTICE:
This feature must be preprogrammed by a qualified
radio technician. Check with your dealer or system
administrator for more information.
Responding to the Notification of
Upgrade
1 The display shows Upgrade? and two short,
medium- pitched tones sound every 30 seconds until
the user makes a choice of either accepting,
delaying, or rejecting the request.
2 Perform one of the following actions:
•
Press the Menu Select button below Acpt to
accept the request to upgrade immediately.
•
Press the Menu Select button below Dlay to
delay the request to upgrade.
•
Press the Menu Select button below Rej to reject
the request to upgrade.
One of the following scenarios occurs:
•
If you choose to accept, the display shows
Programming Dont power off to indicate the upgrade
is about to begin. The radio resets to install the upgrade.
In the case of configuration data upgrade, the process
only takes a few seconds. In the case of firmware
upgrade, the installation takes several minutes.
NOTICE:
The radio cannot be used while the upgrade is
being installed. Therefore, make sure to only
accept the upgrade at a convenient time when
immediate radio use is not required.
•
If you choose to delay, a configuration data upgrade is
installed automatically at the next power up. However, in
the case of a firmware upgrade, the radio prompts
Upgrade? again at the next power up.
•
If you choose to reject, the display shows Upg Aborted.
The radio continues to function with the current
configuration until it gets reprogrammed.
English
147
Advertisement
Table of Contents
